Home > Dekton Glue >

215 ML Feroe Dekton Fast Pre-dosed Glue

Dekton Feroe Glue

Our Price: $29.95

Product Code: M3HFEROE

Description Data Sheets

Consentino DEKTON® Mastidek Cartridge Glue Feroe 215 ML

For use with DEKTON® Feroe surfaces.

Mastidek 215 ML Feroe Cartridge Glue for Cosentino DEKTON® is a new generation bi-component resin used to glue DEKTON® Feroe surfaces. Mastidek outdoor cartridge glue has a very high adhesion in a short amount of time which allows for cutting and polishing the assembled parts in a short time; approximately 45-60 minutes. The hardened product is very shiny and is very polishable.

The Mastidek Feroe adhesive is produced in special cartridges with a 2:1 bi-axial quantity 215 ML. The glue and hardener are pre-dosed in the cartridge which, once inserted in the proper gun, with the special mixer fixed on top, allows the correct extrusion and mixing of the two parts. Mastidek 215 ML Feroe requires use of the special M200XMR Cartridge Gun. This Mastidek glue is suitable for outdoor use.

Directions for Use:

All surfaces must be cleaned and free of dust and grease. When applying Feroe to a polished or glossy surface it is advised to scrub the surface with sandpaper before gluing. Remove cap and attach the special threaded mixing nozzle. Squeeze out about 6" of glue before applying to the DEKTON® surface. Clean the nozzle after use, replace the cap and discard the mixing nozzle. Repeat this process at any change of mixer. After usage, clean the nozzle, replace the cap and discard the mixer after. Product will not set below 32°.

Shelf Life:

The product in the cartridge will last at least 12 months if stored between 65° and 77°. Keep away from sunlight, heat and humidity.


Please read the safety data sheet before use and follow the product instructions.

Share your knowledge of this product. Be the first to write a review »