For use in working with DEKTON® Eter surfaces in indoor and outdoor settings.
Mastidek Eter Cartridge Glue for use on Cosentino DEKTON® Eter is a new generation bi-component resin. Mastidek Eter glue has a very high adhesion in a short amount of time which allows for cutting and polishing the assembled parts in approximately 45-60 minutes. The hardened product is very shiny and is very polishable.
Eter is produced in special cartridges with a 2:1 bi-axial quantity 215 ml. The glue and hardener are pre-dosed in the cartridge. Once inserted in the proper gun, with the special mixer fixed on top, the cartridge allows the correct extrusion and mixing of the 2 parts. Eter cartridges require the use of a special M200XMR Cartridge Gun. Eter cartridge glue is suitable for outdoor use.
Eter is effective for the intended use only when it is used properly. Please be sure to acquaint yourself with how to use and store the adhesive and how to prepare the surface before use. The directions for using Mastidek Eter are as follows:
The product in the cartridge will last at least 12 months if stored between 65° and 77°. Keep away from sunlight, heat and humidity.
Please read the Eter Safety Data Sheet before use and follow the product instructions.
The safety data sheet for 215 ML Eter can be viewed and downloaded by clicking the safety data sheet button below:
Technical information for the 215 ML Eter Mastidek Cartridge is available below. For a printable version of the Eter technical information (including the data below) follow the "Printable Tech Sheet" link below the table.