Consentino DEKTON® Mastidek Cartridge Glue Vera 215 ML
For use with DEKTON® Vera surfaces.
Mastidek 215 ML Vera Cartridge Glue for Cosentino DEKTON® is a new generation bi-component resin used to glue DEKTON® Vera surfaces. Mastidek outdoor cartridge glue has a very high adhesion in a short amount of time which allows for cutting and polishing the assembled parts in a short time; approximately 45-60 minutes. The hardened product is very shiny and is very polishable.
The Mastidek Vera adhesive is produced in special cartridges with a 2:1 bi-axial quantity 215 ML. The glue and hardener are pre-dosed in the cartridge which, once inserted in the proper gun, with the special mixer fixed on top, allows the correct extrusion and mixing of the two parts. Mastidek 215 ML Vera requires use of the special
M200XMR Cartridge Gun. This Mastidek glue is suitable for outdoor use.
Directions for Use:
All surfaces must be cleaned and free of dust and grease. When applying Vera to a polished or glossy surface it is advised to scrub the surface with sandpaper before gluing. Remove cap and attach the special threaded mixing nozzle. Squeeze out about 6" of glue before applying to the DEKTON® surface. Clean the nozzle after use, replace the cap and discard the mixing nozzle. Repeat this process at any change of mixer. After usage, clean the nozzle, replace the cap and discard the mixer after. Product will not set below 32°.
The product in the cartridge will last at least 12 months if stored between 65° and 77°. Keep away from sunlight, heat and humidity.
Please read the safety data sheet before use and follow the product instructions.